Home
> >

Cannondale CAAD12

byeeee

Frame:
2016 CAAD 12, 52cm

Crankset/Bottom Bracket:
Cannondale SI

Pedals:
105 5800

Drivetrain/Cog/Chainring/Chain:
105 5800

Derailleurs/Shifters:
105 5800

Handlebars/Stem:
FSA Wing Pro / Cannondale C2

Saddle/Seatpost:
Thomson Elite because who else makes 25.4 seatposts :'(

Brakes:
105 5800

Front Wheel/Hub/Tire:
Mavic / Open Pave

Rear Wheel/Hub/Tire:
Mavic / Open Pave

Added by Kyono. Last updated almost 2 years ago.

As of about 2 years ago, Kyono has indicated that they no longer own this bike.

9 Comments

SpartaChris

SpartaChris says:

Great looking bike! What is your seat height from the center of the BB to the top of your saddle? I'm debating between sizes and your setup looks about perfect....

Posted about 3 years ago

kill_choi

kill_choi says:

"who else makes 25.4 seatposts" - Get some Kalloy swag.

Posted about 3 years ago

ldizzy25

ldizzy25 says:

hey man, where did you get your headset bearing cover? because i am planning to slam my caad12 as well

Posted over 3 years ago

Kyono

Kyono says:

It's a carbon no-name spacer I found on Ebay- might take some sanding to get it to fit the bearing race properly

Posted over 3 years ago

Robert3210

Robert3210 says:

The straight fork looks so much better than the curved one on the CAAD10. nice bike dude.

Posted over 3 years ago

GeorgeWashingtonMobsDeep

GeorgeWashingtonMobsDeep says:

+1

Posted over 3 years ago

ghostridethewhip

ghostridethewhip says:

+1

Posted over 3 years ago

run_eric

run_eric says:

So clean!! Do you know what the spacer snug between the stem and the headset called?

Posted over 3 years ago

Kyono

Kyono says:

Thanks! It's a carbon 8mm headset spacer- a cheapie from Ebay. I've replaced it with a 5mm 3D-printed part now, so I could use the stock dust seal.

Posted over 3 years ago