Home
> >

Dolan pre cursa

Fall setup

Frame:
Dolan pre cursa 52

Fork/Headset:
Alpina

Crankset/Bottom Bracket:
Miche Advanced

Pedals:
shimano pd 540m

Drivetrain/Cog/Chainring/Chain:
Miche cogs

Handlebars/Stem:
Deda zero 1 / 3t ergonova

Saddle/Seatpost:
Pro griffon / miche supertype

Front Wheel/Hub/Tire:
Miche Pistard / continental supersport 25c

Rear Wheel/Hub/Tire:
Miche Pistard/ continental supersport 25c

Accessories:
Mio ciclo 215, Taxc bottle holder with BBB alu bottle cages.

Bike History

Click a link below to see past stages of this bike.

  1. Initial
  2. Stage 2

Added by Dutchclown. Last updated about 6 years ago.

6 Comments

DoubleAA

DoubleAA says:

Thank you. The 25/28 set up would do. I just hope that the Alpina forks that comes with the new model is the same one that you have.

Posted 4 months ago

Dutchclown

Dutchclown says:

Have you send Dolan a message?
They should be able to give you a accurate answer.

Posted 4 months ago

DoubleAA

DoubleAA says:

I did. They said 23mm for the Alpina Track fork and up to 30mm for the Dolan Road fork without brakes. Rear frame takes up to 30mm as well. I notice a lot of times that the manufacturer are always conservative with their sizing. That's why I'd rather ask here. Thanks.

Posted 4 months ago

DoubleAA

DoubleAA says:

Is this a 2018 model? Also do you think you can put a 28mm or even a 30mm on both fork and rear? Thanks

Posted 4 months ago

DoubleAA

DoubleAA says:

Sorry, I was asking about the tire width. thanks

Posted 4 months ago

Dutchclown

Dutchclown says:

Hi, it's a 2013,
Had to take a look,
28 in the front is a no. 25 just squeezes clear.
at the back 28, or 30 should be possible. Maybe you'll have to fiddle about with a half link to give yourself more room but it should be fine.

Posted 4 months ago