Frame:
Engine11 Bullet (Columbus Airplane Tubing)
Fork/Headset:
Enve 2.0 Road Fork / Columbus Carbon Headseat
Crankset/Bottom Bracket:
Rotor 3D Track / Rotor Steel Cups
Pedals:
Look S-Track MTB Pedals
Drivetrain/Cog/Chainring/Chain:
50-15 / EAI Gold Medal 15T / Rotor Track Chainring 50T / HKK Vertex Gold Chain
Saddle/Seatpost:
Selle SMP Composite Saddle / Enve Seatpost
Front Wheel/Hub/Tire:
Enve Classic 25 / Mack Low Flange 20H / Continental Gatorskin
Rear Wheel/Hub/Tire:
Enve Classic 25 / Mack Low Flange 24H / Continental Gatorskin
More Info:
www.cycleprojectstore.com
Added by jackpotkawa. Last updated over 8 years ago.
12 Comments
+1 on the short stem. It's the only thing that kills this build. Everything else is close to perfect though.
Posted over 8 years ago
Love the bike and the weight is so light you need to tie it to a brick before it flies off
Posted over 8 years ago
brb going to eat a gallon of ice cream as comfort food because of the amount of $$$$ I am looking at in enve stuff.
Posted over 8 years ago
wow. How is look s-track?
Posted over 8 years ago
Totally different from the shimano pedals i've been using but all is well after a couple times of clipping in and out!
Posted over 8 years ago
I was gonna comment on the short stem, but then I noticed you had short stems on all your bikes. I'm assuming you know something about bike fit since you have enve. Short arms?
Posted over 8 years ago
Well these engine 11 frames should allow you to run a longer stem because the top tube is shorter than most track frames
Posted over 8 years ago
sutono says:
nice bullet!
Posted over 8 years ago