Frame:
Argon 18 Electron M
Fork/Headset:
Argon 18 EL99 Track Fork
Crankset/Bottom Bracket:
BB-9000 Dura-Ace HollowTech II bearing cups - 68 mm English thread
Pedals:
PD-9000 Dura-Ace SPD-SL
Drivetrain/Cog/Chainring/Chain:
Dura-Ace FC-7800/Dura-Ace 16T/USE 50T/KMC 710SL
Saddle/Seatpost:
Fizik Antares Carbon Braided/3T Doric Team
Front Wheel/Hub/Tire:
Velocity A23/Dura-Ace HB-7710-F/Continental Supersonic 700x23c
Rear Wheel/Hub/Tire:
Velocity A23/Dura-Ace HB-7710-R/Continental Supersonic 700x23c
Accessories:
Fizik Soft Touch Tape
Added by indysmith. Last updated about 11 years ago.
11 Comments
Real nice! I had the Ergonova's for a bit, but they seemed to be hurting my palms without hoods, it was odd. I'm currently building a Cervelo T1 and would like to buy the bars again. How are they treating you?
Posted about 11 years ago
I really like them, they're comfy on the tops, where the hoods should be, and on the drops. I always wear good mitts with them and I've never had any problems with my hands though.
Maybe check your position on the bike?
Posted about 11 years ago
What's the reason for road cranks?
Posted about 11 years ago
The road cranks are lighter, stiffer and more advanced than their track counterparts! They allow use of a modern 60g Hollowtech II bottom bracket rather than an antiquated square taper design and with the super-stiff USE chainring the chain line is perfect.
Check out http://www.use1.com/product/000044/chai...
Posted about 11 years ago
Clean build man! this thing must be pretty dam light and fast!
Posted about 11 years ago
Bang on 15lb UCI weight limit, and it goes as fast as I can spin my legs! I'm going to gear it up a bit I think
Posted over 10 years ago
Photos
rutzkakaputzkah says:
The Most beautiful trackbike i've seen. Perfect setup, actually i'm very conferm with the dura ace cranks.
Posted over 9 years ago