see ya.
Frame:
Firefly Stainless Steel Road - 56cm [custom]
Fork/Headset:
ENVE 2.0 - Chris King (Sotto Voce)
Crankset/Bottom Bracket:
SRAM Red 165mm - PF30 BB
Pedals:
Look Keo Blade Carbon Cromo- 12Nm
Drivetrain/Cog/Chainring/Chain:
SRAM Etap / 12-28 / 50-34
Derailleurs/Shifters:
SRAM Etap
Saddle/Seatpost:
Brooks Cambrium C13 -158cm / ENVE
Brakes:
SRAM Red
Front Wheel/Hub/Tire:
ENVE 3.4 / Chris King r45 / Vittoria Corsa Control 25c
Rear Wheel/Hub/Tire:
ENVE 3.4 / Chris King r45 / Vittoria Corsa Control 25c
Accessories:
Rapha Brevet bar tape / Wahoo Elemnt Roam / Wahoo Speed & Cadence sensors / Andrew's King Iris Stainless Steel Cages / Jagwire cable kit
Bike History
Click a link below to see past stages of this bike.
Current Stage Info:
Updated for 2020
Added by sheepdog84. Last updated over 3 years ago.
As of over 3 years ago, sheepdog84 has indicated that they no longer own this bike.
12 Comments
What are you using for a font skewer?
Posted over 7 years ago
That's a pair of skewers i found off ebay a few years back.. i think they're Ti, but they're bombproof!
Posted over 7 years ago
Did you buy this from Firefly or is it 2nd hand? I think it's a nice touch to go with handbuilt wheels on a handbuilt bike. I also like the look of a Thomson cockpit on a traditional tubed frame. That said, I'm sure whatever you go with will look excellent.
Posted over 7 years ago
I did buy this second hand, but it included the geometry build sheet, so I was able to measure against my previous frame to make sure it would fit. Which actually fits me better than my R5..
As far as wheels go, I'm probably sticking with my handbuilt set until they fall apart. Not entirely sold on carbon clinchers yet.
Other components are going to be carbon where I can to save a little weight.
Posted over 7 years ago
hawaiifixed says:
Beautiful!!
Posted about 7 years ago
sheepdog84 says:
hey thanks!!
Posted about 7 years ago